The Ritual Guide
Your Frame Pulse Activator.
How to use it.
Hands-free. Eyes closed. Ten minutes.
Frame Pulse Activator — used daily or every other day
Before You Begin
Cleanse + Serum
Start on clean skin. Apply your preferred serum to the treatment area.
Position
Place the device along the orbital bone. Adjust straps for a snug, comfortable fit.
Time
Set aside 10 minutes. This is a hands-free ritual — close your eyes.
The Sequence
Use each mode in order. Each builds on the last.
Select Program
Pre-programmed pulse patterns
Duration: 10 seconds
What it does: Pre-programmed pulses target different muscle groups. Choose intensity level based on experience.
Sensation: Button feedback only. No sensation yet.
EMS Training
Electrical muscle stimulation, auto-cycle
Duration: 10 minutes (automatic)
What it does: Contracts and releases facial muscles for tone and depuffing across the full treatment zone.
Sensation: Light rhythmic pulse. Comfortable. Adjust intensity if needed.
LED Array
Full-spectrum LED, simultaneous
Duration: Runs simultaneously with EMS
What it does: Full-spectrum LED stimulates collagen across the entire zone during the EMS cycle.
Sensation: Gentle warmth. Keep eyes closed throughout.
How often?
Daily or every other day. The best ritual is the one you actually do.
After Your Session
Remove
Gently remove the device. Wipe contact points clean.
Eye Care
Apply eye cream or serum immediately while absorption is highest.
SPF
If morning, finish with SPF. LED increases light sensitivity slightly.
When not to use it
- Active skin infections or open wounds in treatment area
- Pregnancy
- Implanted electronic devices (pacemakers, cochlear implants)
- Epilepsy (due to light pulses)
- Metal implants in the face
If in doubt, consult your doctor first.
Questions about your device?
Email us at info@zentialpure.com