The Ritual Guide
Your Face Introducer.
How to use it.
Three technologies. One sequence. Five minutes.
Face Introducer, used 5× per week
Before You Begin
Cleanse
Start on clean, dry skin. No moisturizer yet.
Gel
Apply the included conductive gel to areas you'll treat.
Space
Set aside 5–10 minutes. No rushing the ritual.
The Sequence
Use each mode in order. Each builds on the last.
Thermal Warm-Up
40–42°C gentle heat
Duration: 60 seconds
What it does: Increases blood circulation and prepares tissue for deeper penetration of subsequent modes.
Sensation: Gentle, steady warmth. Like holding a warm stone against your skin.
Microcurrent
Low-frequency electrical current, sub-sensory threshold
Duration: 60 seconds per zone (forehead, cheeks, jawline)
What it does: Re-educates facial muscles. Clinically used for facial contouring and lift.
Sensation: A faint tingling or nothing at all. If it feels uncomfortable, reduce contact pressure.
EMS Finish
Electrical muscle stimulation
Duration: 60 seconds
What it does: Produces gentle muscle contractions to tone and firm. Completes the three-modality cycle.
Sensation: A light pulse. Normal. Adjust intensity with the side button.
How often?
5 sessions per week for the first 4 weeks. After that, 3 sessions per week as maintenance. Consistency matters more than intensity.
After Your Session
Rinse
Remove any remaining gel with warm water.
Serum
Apply your preferred serum immediately. Absorption is highest right after treatment.
SPF
Always finish your morning ritual with SPF. Warmed skin and fresh serum are no substitute for sun protection.
When not to use it
- Active skin infections or open wounds in treatment area
- Pregnancy
- Implanted electronic devices (pacemakers, cochlear implants)
- Epilepsy (due to electrical stimulation)
- Metal implants in the face
If in doubt, consult your doctor first.
Questions about your device?
Email us at info@zentialpure.com